16058 Image IMAGE: requested laser power of %lu.%03lu Watts is above the limit of %lu.%03lu Watts Thermal The requested laser power before a plot was higher than the preset limit. The limit is hard-coded and dependent on the type of head (20W or 40W). Both the requested power and the limit are specified in the error message. Check that the correct media type was selected for the current image, then try the image again. If the problem persists, call Creo Customer Support for help. Or, if a laser power test series plot was started or underway, the requested laser power was higher than the capabilities of the imaging head. In this case, specify a lower power level or a lower step increment value. The NVS hdm wpower setting may be too high. The workstation specified a media type that was not normally used, and has a NVS hdm wpower setting that is too high. A wpower series plot was started or underway, and the requested laser power for the next series step was beyond the hard-coded limit for the current head type. The recorder has a lower power head than you think it has. ../commands/plot_wpower.xmlCommand: plot wpower ../nvs/hdm_cal_wpower.xmlNVS: hdm wpower ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:31 2008 PST